You must configure second hard drive to Slave mode by setting the jumper accordingly. Are you asking if you were to boot to a Windows installation disk would the computer run? The CD can be used with any suitable Product Key. I think it is morning at your side of the world. Remove all the ram. It sounds like the 6. At any rate, I would avoid both of those links.

Uploader: Faezshura
Date Added: 2 March 2006
File Size: 54.65 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 77485
Price: Free* [*Free Regsitration Required]

You indicated a message; “If you give permission to overwrite a bad sector SeaTools will attempt to write a pattern of zeros to that sector. Verr is NO jumper in the pins now.

Do you have a monitor to connect to the tower? Thanks for guiding me through this so far. I listened very closely and there was no sound from the floppy drive. It is easy to test for incompatible ram that has caused your mboard to fail to boot.

MSI MS Ver 5, Socket , Intel Motherboard | eBay

Ms-66714 could try using the 6. This doesn’t make sense to me, because if the Repair installation method is not available in Setup for the Windows CD’s, why would I want the Product Key, unless I borrowed a CD from someone to install it from scratch and therefore needed to determine the Product Key using a third party program such as Magic Jelly Beanbut then, because I am not the owner of the Product Key, it would be illegal to use it if the owner of it had it installed in another computer?


If your Boot Order or similar settings are set so the floppy drive is listed first in the bios Setupthat cer work fine. All the beep codes listed are a series of whatever and this one is just as I said, 1 beep every 4 seconds going on and on and on.

MS | Hp MS GV Socket Motherboard

I ger to buy a brand new hard disk drive in the near future that would be ideal for my circumstances. Can one copy an OS that is installed on a hard disk from that hard disk to a CD? I haven’t yet learned much about graphic accelerator cards.

In response to above. Can you use the 40gb drive?

Hey but those guys who wrote those programs were the pioneers so thumbs up to them! Yay, I’m learning a lot. It’s probably this one: If there are two drives on a data cable, if either one or both require an 80 wire data cable, you are supposed to use an 80 wire data cable.

Help me resurrect a throw-away MS-6714 VER:1

I don’t want to overdo things, and since I am still an amateur I feel I first need to learn to understand the world of storage a bit better. Net is the opinions of its users.

Thanks for also answering all my other questions, and for providing more information. There is often also a selection for Network ms-67144 or similar – in most cases, unless the computer is supposed to be connecting to an institutional e.


I must try the Old Data Lifeguard Diagnostic at http: Capacity The formatted size of the storage device. Do you hear any beeps when you start the computer?

First I should clarify what a system disk is. If you don’t have one, someone you know might have one. This information should be provided in the documentation from your hard disk vendor or the system manufacturer.

If so, the answer is no.

MSI Ms-6714 Ver 5 Socket 478 Motherboard Backplate Included

In that case, you don’t need to change the Boot Order or similar when you want to boot from a bootable floppy disk, a bootable CD or DVD, or a bootable hard drive. Doesn’t necessarily need to be a hard drive. Make sure you have a speaker or speakers or the equivalent connected to the mboard so you can hear mboard beeps see your mboard manual if you need to.

When you boot the from the XP CD, some initial files will load from the Md-6714, then you will see a screen where you can choose to Repair Windows or to Continue on to Setup – choose the latter choice. The front LED of the floppy drive never came on while the computer was running.

Look at the specs and the picture of the mboard.